Step1:        Planning Guide: Please print, complete and fax with name and phone# to 1 315 698-7859
Personal Planner Floorplan Grid    Draw your kitchen to scale. Dimensions must be accurate.


Each square on grid = (1) foot
Step 2:   Front Edge Options:
                   Please circle your choice

If you are ordering a Stainless Steel Countertop to fit over your existing countertop...
ONLY the Radius Front Edge is available.

In order to provide customers with a sleek, finished look, it is necessary to reduce any large radius (curves) edges or corners in our design.  Therefore, if the existing countertop has a large radius (curve) where the countertops joins the backsplash - it will be necessary for you to provide the length of the radius by precisely measuring from the "outer" edge of the front of the countertop (C) to the point where the curve of going into the backsplash begins (A) on the backsplash.
Next: measure from the front "outer" edge of the Countertop (C) to the front "flat" of the backsplash (B).  Note: This is same measurement - Item G requested in Step 5. 
See drawing below.
Step 3:
Backsplash Options & Dimensions
   [  ] No backsplash required.

Type/Design of backsplash:
Please circle your choice.
Height of backsplash: __ inches

Step 4:
Sink/Cooktop Dimensions: If Sink/Cooktop Make & Model is not available, you must accurately measure and provide the "cut-out" dimensions, Items - A, B.  C, D as requested in Step 5.
Sink Make & Model - ____________________
                                     Found on bottom side of sink
Cooktop Make & Model - _______________________

Step 5:
Sink/Cooktop Dimensions: Top View-looking down on countertop & sink

Note:  Be Accurate in your measuring - to increments of 1/16th of a inch

Measurements must be done from under sink or cooktop.  DO NOT measure top edges of sink where it meets countertop.

A -
B -
C -
D -
E -
F -
G -
H -

 ___ inches - Distance from back edge of cut-out to the back wall.
 ___ inches - Distance from the front edge of cut-out to the front edge of countertop.
 ___ inches - Distance from front edge of cut-out to the back edge of cut-out.
 ___ inches - Distance from left side of cut-out to right edge of cut-out.
 ___ inches - Distance from left side of cut-out to the end of the counter.
 ___ inches - Distance from right side of cut-out to the end of the counter.
 ___ inches - Distance from "outer" point of front edge to the front of the backsplash
 ___ inches - Distance from wall to front of Backsplash = thickness of Backsplash

Step 6:
Frigo Design Sink Options: To provide you an accurate quotation for the perfect sink please
provide us as much of the following sink information possible.

Sink Style: _________________________
Kitchen or Vanity
Metal: _________________________
Stainless or Copper
Size: _______x_______       Bowl Depth: __________       # of Bowls: __________
Width x Depth8" or 10"1, 2 or 3
Options:
Double Bowl Sink - One Bowl Larger than the other
Sink with built in Drain Board
Frigo will review the following request and provide a quotation on one or two sinks for your approval.

If you have any questions as to the information, dimensions or "how to measure"...
please call Frigo Design at: 1 800 836-8746.
Don't guess at measurements & don't round off measurements
Accuracy/ precision dimensions are required to ensure a "perfect fit".
Fax # - 1 315 698-7859



After you have completed all the information on the Planning Guide please fax with your name and phone#
to 1 315 698-7859